Henry^® Termination Bar is an extruded aluminum bar that is designed for securing and sealing compression type flashing terminations. Termination Bar has pre-punched holes every 6" on center. Termination Bar features an extended top edge for ease of applying Henry Lap Sealant for Henry EPDM installations or Henry Single-Ply Sealant for Henry TPO installations. Termination Bar can be easily cut to any desired length. When installing, make sure that all corners of the cut bar are rounded. Install the Termination Bar using a threaded masonry fastener or masonry nail-in anchors.

Features and Benefits

• Termination bar can be easily cut to any desired length
• When installing, make sure that all corners of cut bar are rounded
• Install termination bar using a threaded masonry fastener or masonry nail-in anchors

Size available

• 1 in. x 10 ft. bar

Complete the system

Insulation Fasteners

Insulation Fasteners & Plates

Insulation Fastening Plates

• Installation and Technical Literature

  Termination Bar TDS Sheet  

Tools